Table of Contents
Advertisement
About this guide
HP mc-Series 5042 Rack options installation guide
This installation guide includes instructions for installing the option kits that are compatible with the HP
mc-Series 5042 Rack.
For more information, see the HP mc-Series 5042 Rack User Guide on the HP website
(http://www.hp.com/go/rackandpower).
Safety information
The HP mc-Series 5042 Rack is tested to the maximum pressure (PS) of 8 bar (116 PSI) without fluid trapped
inside by closed, external valves.
If valves are installed on the external pipe work that might trap fluid inside the MCS 5042 rack, you must take
special precautions. To prevent severe plumbing failure due to extreme pressure, use an expansion tank with
a preinstalled safety valve in the plumbing circuit connected to the unit.
Optimum environment and site preparation
CAUTION:
service. The water flowing into the MCS 5042 unit must meet the guidelines stated in the HP
mc-Series 5042 Site Preparation Guide. The MCS 5042 warranty does not cover damage
caused by contaminated water.
IMPORTANT:
Preparation Guide.
To provide optimum performance with minimum maintenance for your unit, environmental requirements must
be met.
The HP mc-Series 5042 Site Preparation Guide provides information about planning your unit configuration
efficiently and organizing your site location before delivery of your MCS 5042 unit.
To locate the latest version of the HP mc-Series 5042 Site Preparation Guide:
Go to the HP website (http://www.hp.com/go/rackandpower).
1.
Select Rack and Rack Options.
2.
Select Modular Cooling System.
3.
Select Support and Documents.
4.
Select Manuals.
5.
Select and download the HP mc-Series 5042 Site Preparation Guide.
6.
To route water lines to your MCS 5042 unit, use one of the following methods:
•
Through an opening in the raised floor
Contaminated water might cause decreased cooling capacity or disruption in
Before you begin the installation process, review the HP mc-Series 5042 Site
About this guide 5
Advertisement
Table of Contents
