HP D7171A - NetServer - LPr Configuration Manual page 3

Introduction
This document defines the supported HP NetServer LH Pro configurations for Microsoft Cluster Server.
These configurations minimize single points of failure, provide maximum availability, and have been
certified by Hewlett-Packard and Microsoft. This guide is prescriptive; it describes the HP NetServer LH
Pro configurations supported by HP. Any configuration not expressly allowed by this guide will not be
supported by HP.
What's Defined
Cluster
SPUs
Local and Shared Storage
Intra-cluster and Client LANs
Cluster
Type of SPUs
Number of nodes
Shared Storage
LANs:
Client LAN
Intra-cluster
(Heartbeat) LAN
Power source
System software:
Navigator version
Operating System
Service pack
HP NetServer LH Pro
with
NetRAID (HP Storage System/6)
Cluster Configuration Guide
17 November 1998
HP NetServer LH Pro 6/200 Model 1
Each node must be the same model SPU, but may have different size main
memory and cache.
2
HP Storage System/6 with HP NetRAID controller and HP disks. See
Shared Storage below.
Any NIC that is HP and Microsoft approved. See
HP D5013A or J3171A only with crossover cable. See
below.
Direct from power mains, power conditioner or uninterruptable power
supply (UPS) using any power conditioner or UPS.
G.00.80 or later
Microsoft Windows NT Server 4.0, Enterprise Edition or later.
SP3 and hotfix "clusfixi", or later. The hotfix is not required but is
recommended for clusters using 9.1GB and higher capacity drives.
1
Client LAN below.
Intra-cluster LAN