Migrating From Professional Plus Edition To Enterprise Edition On Unix Systems - Brocade Communications Systems StorageWorks 1606 - Extension SAN Switch Installation Manual

•
•
Migrating from Professional Plus edition to Enterprise edition on UNIX
systems
Use the following procedure to migrate from Professional Plus edition software to Enterprise edition
software on a UNIX management server.
1. Insert the installation DVD into the DVD-ROM drive and open the following file.
2. Click Next on the Introduction screen.
3. Read the agreement on the License Agreement screen, select I accept the terms of the
4. Select the usual location for your system's application files (for example, /opt/DCFM10_3_X)
5. Review the displayed installation summary on the Pre-Installation Summary screen and click
6. Make sure the Launch DCFM Configuration check box is selected (default) on the Installation
7.
DCFM Installation, Migration, and Transition Guide
53-1001360-01

Migrating from Professional Plus edition to Enterprise edition on UNIX systems

Make sure that the DISPLAY environment variable is correctly defined in the shell with a valid
value (for example, to display to the local console,
remote system that has an X Server running, export DISPLAY=
You may also need to consider a firewall that might block the display to the X Server which
listens by default on TCP port 6000 on the remote host.
To display to a remote system you need to permit the remote display of the X Server by running
command xhost +IP, where IP is the IP address of the DCFM server host from the X based
desktop of the remote system.
Make sure you test the DISPLAY definition by running the command xterm from the same shell
from which you run
install.bin
should open.
<DVD_Drive>\DCFM\<UNIX_Platform>\install.bin
License Agreement and click Next.
or the location of the partially uninstalled Professional Plus edition on the Select Install Folder
screen and click Next.
Do not install to the root directory (for example, /).
Install.
Complete screen, and click Done.
Click Next on the Welcome screen.
export DISPLAY=:0.0
. A new X terminal window to the destination X Server display
, or to display to a
:0.0).
<Remote_IP_Address>
2
153