Brocade Communications Systems StorageWorks 1606 - Extension SAN Switch Installation Manual page 146

2
Migrating from Professional Plus trial to Professional Plus edition on UNIX systems
14. Complete the following steps on the Server Port Configuration screen.
15. Verify your configuration and license information on the Server License Summary screen and
16. Select the Start Client check box, if necessary, on the Start Server screen and click Finish.
130
NOTE
Do not use port 2638 for any of these port numbers. Port 2638 is used internally by the server.
FIGURE 58 Server Port Configuration screen
a. Enter a port number in the Syslog Port Number field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog
messages from the device.
b. Enable SSL by selecting the SSL Enabled check box.
c. Enter a port number in the Web Server Port Number field (default is 443 if SSL Enabled is
selected; otherwise, the default is 80).
d. Enter a port number in the SNMP Port Number field (default is 162).
e. Enter a port number in the Starting Port Number field (default is 24600).
NOTE
The server requires 16 consecutive free ports beginning with the starting port number.
f. Click Next.
If you enter a Syslog port number already in use, a message displays. Click OK to close the
message. Edit the Syslog port number and click Next.
If you enter a port number already in use, a Warning displays beneath the associated port
number field. Edit that port number and click Next.
click Next.
After all of the DCFM services are started, the Log In dialog box displays.
DCFM Installation, Migration, and Transition Guide
53-1001360-01