HP StorageWorks P9000 Reference Manual page 17

Table 2 Basic Information in Audit Log File (continued)
No. Item File 1 (SVP)
12 Result The result of your operation.
xxxxx-yyyyyy is an error code. xxxxx is a
part code of four or five digits showing
where the error occurs. yyyyyy is a
message ID of four, five, or six digits. For
more information about error codes, see
the HP StorageWorks P9000 Remote
Web Console Messages.
NOTE:
only for Remote Web Console operations.
13 Host An IP address (IPv4 or IPv6) is output for
Identification Remote Web Console, RMI AP and SVP
operations. The IP address may be that of
the proxy server or the router depending
on the configuration of the connected
network.
No output for RM AP operations. No
output when the user name is <System>.
If both IPv4 and IPv6 are available for
communication between the Remote Web
Console computer and the SVP, you can
specify the IPv6 address of the SVP in the
Web browser, but the Remote Web
Console secondary window uses IPv4
communication. In this case, IPv4
addresses are output to audit logs.
For details about configuring only IPv6
communication, see the section describing
IPv6 communication in the HP
StorageWorks P9000 Remote Web
Console User Guide.
14 Application No output
Identification
15 Serial number The serial number of the saved log
information (0000000000 to
4294967295). When the number
reaches 4,294,967,295, it is reset to
0000000000.
Detailed Information
Detailed information in the audit log file 1 (SVP) contains index and setting values. Detail information
in the audit log file 2 (DKC) contains command names and parameters received from a host.
Normal end. The operation has ended
normally.
Error (xxxx-yyyyy). The operation has
ended abnormally.
Warning (xxxx-yyyyy). The operation
has partly ended abnormally or was
canceled during the operation.
Error codes "xxxx-yyyyy" appear
File 2 (DKC)
The result of the received commands.
Normal end. The authentication has ended
normally.
Error. The authentication has ended
abnormally.
Accept. Received the commands from the host.
Reject. Rejected the commands from the host.
A host name is output for commands from
hosts through SVP.
A WWN is output for the FC-SP
authentication.
A WWN is output for commands from
open-system hosts.
A serial number is output for commands
mainframe system hosts.
If a command comes from other storage
system, the WWN or serial number of the
storage system is output.
An internal-use ID is output for open-system
hosts.
An LPR number is output for mainframe system
hosts.
0x0000 is output if a command comes from
other storage system.
No output for other commands.
Same as File 1.
Audit log file format 17