Dhcp Server Configuration - Thecus N16000 Series User Manual

LAN2 Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
Gateway
Link Detected
Lick Speed
NOTE
NOTE

DHCP Server Configuration

A DHCP server can be configured to assign IP addresses to devices connected to the
LAN2 port. To configure these ports, choose LAN2 from the System Network
menu.
DHCP Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
Description
Displays the MAC address of the LAN2 interface.
Enable or disable Jumbo Frame Support on the LAN2 interface.
Specifies the IP address of the LAN2 interface.
Specifies the Network Mask of the LAN2 interface.
When Thecus NAS as a DHCP server from LAN2, it can have
another route to balance traffic bandwidth for its DHCP
clients
Specifies the LAN2 port link status
Specifies the LAN2 port link speed
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your Thecus IP storage.
If the IP sharing mode setting is set to "Enable" under WAN/LAN21 port, then this 2
gateway cannot be configured.
Description
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN2 interface.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Displayed the DNS server IP address.
37
nd