Notification Configuration; Firmware Upgrade - Thecus N16000 Series User Manual

Act as NTP Server
Sync with external NTP
Server
WARNING

Notification configuration

From the menu, choose the Notification item, and the Notification
Configuration screen appears. This screen lets you have Thecus IP storage notify
you in case of any system malfunction. Press Apply to confirm all settings. See
following table for a detailed description of each item.
Notification Configuration
Item
Beep Notification
Email Notification
SMTP Server
Port
Auth Type
SMTP Account ID
Account Password
E-mail From
Receiver's E-mail
Address (1,2,3,4)
NOTE

Firmware Upgrade

From the menu, choose the Firmware Upgrade item and the Firmware Upgrade
screen appears.
Select Enable to synchronize with the NTP server.
Select Disable to close the NTP server synchronization.
Select YES to allow Thecus IP storage to synchronize with an NTP
server of your choice. Press Apply to change.
If an NTP server is selected, please make sure your Thecus IP storage has been
setup to access the NTP server.
Description
Enable or disable the system beeper that beeps when a problem
occurs.
Enable or disable email notifications of system problems.
Specifies the hostname/IP address of the SMTP server.
Specifies the port to send outgoing notification emails.
Select the SMTP Server account authentication type.
Set the SMTP Server Email account ID.
Enter a new password.
Set email address to send email.
Add one or more recipient's email addresses to receive email
notifications.
Consult with your mail server administrator for email server
information.
28