Lan Configuration; Dhcp Configuration - Thecus N4100+ User Manual

LAN Configuration

The N4100+ supports a second Ethernet
port for higher service availability. To
configure these ports, choose LAN from the
Network menu, and the LAN
Configuration screen appears. Press Apply
to save your changes.
LAN Configuration
Item
MAC Address
IP
Netmask
Jumbo Frame Support
NOTE

DHCP Configuration

A DHCP server can be configured to assign IP addresses to devices connected to
the LAN port. To configure these ports, choose LAN from the Network menu.
DHCP Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
NOTE
WARNING
Description
Displays the MAC address of the LAN interface.
Specifies the IP address of the LAN interface.
Specifies the Network Mask of the LAN interface.
Enable or disable Jumbo Frame Support on the LAN interface.
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your N4100+. In this case, you have to reset the system back to default
by the holding down front panel reset button for 5 seconds during boot up process.
Description
Enable or disable the DHCP server to automatically assign IP
addresses to PCs connected to the LAN interface. Default is
Disabled.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Specifies the DNS server IP address.
The IP Segment of WAN and LAN should not overlap.
The IP address of the LAN interface should not be in the range of the Start IP
address and End IP address.
30