Table of Contents
Advertisement
WARNING
LAN Configuration
The 1U4500 supports two Gigabit Ethernet
ports for higher service availability. To
configure these ports, choose LAN from the
Network menu, and the LAN
Configuration screen appears. Press Apply
to save your changes.
LAN Configuration
Item
MAC Address
IP
Netmask
Jumbo Frame Support
NOTE
DHCP Configuration
A DHCP server can be configured to assign IP addresses to devices connected to
the LAN port. To configure these ports, choose LAN from the Network menu.
DHCP Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
NOTE
WARNING
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo
Frame and you will not be able to connect to your 1U4500 after Jumbo
Frame is turned on. If this happens, turn off the 1U4500. Then, power
on the 1U4500 and immediately press and hold the Reset button on
the back of the unit for 10 seconds. This will reset your network
settings, password, and turn off Jumbo Frame Support.
Description
Displays the MAC address of the LAN interface.
Specifies the IP address of the LAN interface.
Specifies the Network Mask of the LAN interface.
Enable or disable Jumbo Frame Support on the LAN interface.
Before enabling Jumbo Frame Support, please make sure your network
equipment supports Jumbo Frame. If your equipment is incompatible,
you might not be able to connect to your 1U4500. In this case, you
have to reset the system back to default by the holding down front
panel reset button for 5 seconds during boot up process.
Description
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN interface.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Displayed the DNS server IP address.
The IP Segment of WAN and LAN should not overlap.
The IP address of the LAN interface should not be in the range of the
Start IP address and End IP address.
42
Advertisement
Table of Contents
