GM-XPortH
Symptom
Audio is not output
• Check that the Bluetooth device and Wireless receiver (RX101)
when a wireless
are correctly paired.
receiver (RX101 is
connected).
GRemote control unitH
Symptom
The set cannot be
• Batteries are worn out. Replace with new batteries.
operated with the
• Operate the remote control unit within a distance of about
remote control unit.
23 ft/7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
Cause/Solution
19, 89, 90
Cause/Solution
Resetting the microprocessor
Page
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
X ON/STANDBY
Page
83
83
83
83
1
Turn off the power using
83
2
X ON/STANDBY
Press
CH –
.
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
93
PRESET CH +
PRESET CH –
X ON/STANDBY
.
PRESET CH +
while simultaneously pressing
PRESET
and