Marantz NR1403 Owner's Manual page 21

Connecting an FM/AM antenna
• Connect the FM antenna supplied with the unit to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
broadcasts"), fix the antenna with tape in a position where the noise level becomes minimal.
n AM loop antenna assembly
1
Put the stand section through the bottom of the
loop antenna from the rear and bend it forward.
2
Insert the projecting part into the square hole in
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Nail, tack, etc.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.
• If the signal has noise interference, connect the ground terminal (GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For
details, inquire at the retail store where you purchased the unit.
(vpage 30 "Listening to FM/AM
Stand
Square
Loop
hole
antenna
Projecting
part
Standing alone
Use the procedure shown above to assemble.
AM loop antenna
(supplied)
q
Black
White
AM outdoor
Ground
antenna
18
Connecting an HDMI-incompatible device
Direction of broadcasting station
75 Ω coaxial
w e
cable
FM indoor antenna
(supplied)
FM outdoor
antenna