Marantz NR1403 Owner's Manual page 95

GAudioH
Symptom
Audio is not output. • Check the connections for all devices.
• Check the speaker connections and configurations.
• Check whether the audio device power is turned on.
• Adjust the master volume.
• Cancel the mute mode.
• Check the connection with the playback device and select the
proper input source.
• Match the input mode and the terminal assigned to be the digital
input terminal.
• Disconnect the headphones. No sound is output from the
speakers when headphones are connected.
The volume does not • The maximum volume is set too low. Set the maximum volume
increase. under "Limit" in the menu.
• Power for external devices connected to the output connectors
of the unit may not be turned on. Check the power of connected
external devices.
No sound is • Check if the surround speakers are connected to the SURROUND
produced from terminals.
surround speaker.
No sound is • Check the subwoofer connections.
produced from
subwoofer. • Turn on the subwoofer's power.
• Set "Speaker Config." – "Subwoofer" on the menu to "Yes".
• If "Front" and "Center" for "Speaker Config." are set to "Large",
and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected
sound mode.
DTS sound is not • Set "Decode Mode" on the menu to "Auto" or "DTS".
output.
Dolby TrueHD, DTS- • Make HDMI connections.
HD, Dolby Digital
Plus audio is not
output.
Cause/Solution
9, 10, 13,
14, 15, 16,
17, 18, 19
45, 46, 47
45, 46, 47
Symptom
Page
• Check that "Speaker Config." – "Center" or "Surround" is set to
Dolby PLg mode or
other than "None". If the speaker system is 2.0/2.1ch, this sound
DTS NEO:6 mode
mode cannot be selected.
cannot be selected.
• When headphones are used, Dolby PLg or DTS NEO:6 cannot be
selected.
Audyssey MultEQ ® ,
• Switch the sound mode to other than "DIRECT" or "PURE
Audyssey Dynamic DIRECT".
– EQ ® and Audyssey • When headphones are used, Audyssey MultEQ ® , Audyssey
29 Dynamic Volume ® Dynamic EQ ® and Audyssey Dynamic Volume ® cannot be
29
cannot be selected. selected.
28
• Run Audyssey ® Setup.
Audyssey Dynamic
EQ ® and Audyssey
69
Dynamic Volume ®
cannot be selected.
79
M-DAX cannot be • Check that an analog signal or PCM signal (Sample rate=44.1/48
selected. kHz) is input. For playback of multichannel signals such as Dolby
61
Digital or DTS surround, M-DAX cannot be used.
• Switch the sound mode to other than "DIRECT" or "PURE
–
DIRECT".
GFM/AM tunerH
–
Symptom
Reception fails, or • Change the antenna orientation or position.
there is a lot of noise • Use an FM outdoor antenna.
or distortion. • Separate the antenna from other connection cables.
–
72
72
70
10
92
Cause/Solution
Cause/Solution
Page
72
–
38
–
21
60
38
Page
18
18
18