Marantz NR1403 Owner's Manual page 26

Preparation (Continued)
4
Select "Start" and then press
ENTER
.
The subwoofer volume setting screen
is displayed.
5
Select "Next" and then press ENTER
Audyssey Setup
I f y ou r s ubwo ofer has a vol ume contr ol
o n i t, p l eas e s et it at 50 % . . .
VOLUME
MIN MAX
Back Next
Detection & Measurement (Main)
• This step automatically checks the speaker configuration and speaker
size, and calculates the channel level, distance, and crossover
frequency.
It also corrects distortion in the listening area.
6
Select "Begin Test" and then press
. When measuring begins, a test tone is output from each
speaker.
• Measurement requires several minutes.
7
MultEQ The detected speakers are displayed.
• The illustration below shows an example of when the front
speakers, center speaker, subwoofer and surround speakers have
been detected.
NOTE
If a connected speaker is not displayed, the speaker may not be
connected correctly. Check the speaker connection.
8
Select "Next" and then press
ENTER
.
Audyssey Setup
MultEQ
Speaker Detection
Front Yes
Center Yes
Subwoofer Yes
Surround Yes
Repeat Last Test Next
ENTER
.
23
Set up speakers (Audyssey ® Setup)
NOTE
If "Caution!" is displayed on TV screen:
Go to "Error messages" (vpage 26).
Check any related items, and perform the
necessary procedures.
If the problem is resolved, return and restart
"Audyssey ® Setup".
Going back to the previous screen
ENTER
Select "Back" and then press .
When measuring has stopped
BACK
q Press to display the popup screen.
o ENTER
w Press to select "Yes", and then press
Setting up the speakers again
Repeat the operation from step 3.
.