General Safety Information - Motorola V186 - Cell Phone - GSM System Planner Manual

GENERAL SAFETY INFORMATION:

WARNING:
Installation of the ACE3600 should be done only by authorized and
qualified service personnel in accordance with the US National
Electrical Code. Only UL Listed parts and components will be used for
installation.
Use UL Listed devices having an environmental rating equal to or
better than the enclosure rating to close all unfilled openings. If the
installation involves high-voltage connections, technicians must be
specifically qualified to handle high voltage. If the I/O connections are
powered by a hazardous voltage (>60VDC or >42Vpeak), all inputs
should be defined as hazardous and the unit must be installed in a
restricted access area for service personnel only.
If the I/O connections are powered by a safety extra low voltage
(SELV) (<60VDC or <42Vpeak), all inputs should be defined SELV.
INSTALLATION CODES
This device must be installed according to the latest version of the
country's national electrical codes. For North America, equipment
must be installed in accordance to the applicable requirements in the
US National Electrical Code and the Canadian Electrical Code.
INTERCONNECTION OF UNITS
Cables for connecting RS232 and Ethernet Interfaces to the unit must
be UL-certified type DP-1 or DP-2. (Note- when residing in a non LPS
circuit.)
OVERCURRENT PROTECTION
A readily accessible Listed branch circuit over current protective
device rated 20 A must be incorporated in the building wiring.
ACE3600 Installation Guidelines
87