Switch Settings On The Hot Swap Subsystem - HP D5970A - NetServer - LCII User Manual

Chapter 4

Switch Settings on the Hot Swap Subsystem

Figure 4-3 shows the switch settings on the rear of the hot swap subsystem cage.
Switch settings are listed in the next section. The default settings can be found on
the Technical Information Label, located on the side of the chassis, and in
Information Assistant. Switches 3 and 4 determine the SCSI address of each hot-
swap shelf.
On
Off
1
2
3
4
5
6
Technical Information Label
with configuration information
Figure 4-3. Hot Swap Subsystem Switch Location
Configuring Mass Storage
21