5 Installing UPS Software
Before Installing UPS Software
Software for configuring, monitoring and managing the HP PowerWise UPS is
located on the HP NetServer Navigator CD-ROM.
Before installing your UPS software, you must first do the following steps:
Install your UPS using the instructions in Step 2 of the HP NetServer
LD Pro Road Map.
Install your Network Operating System.
(Optional) Install server management software using the instructions in
the NetServer Assistant Installation Guide.
The following sections describe the UPS installation procedures for Microsoft
Windows NT and Novell NetWare.
UPS Installation for Microsoft Windows NT
NOTE
Refer to the README file located in the \pwa\winnt\disk1
directory for any updates to the installation procedure.
Before installing the software, make sure that:
Your HP PowerWise UPS is plugged in, turned on, and connected to the
server via the serial cable. (See the instructions in the HP NetServer
LD Pro Road Map.)
Microsoft Windows NT is up and running on your HP NetServer.
If you are using HP OpenView for Windows to manage your HP PowerWise UPS,
make sure that:
HP OpenView for Windows is installed on your central management
console
TCP/IP and SNMP services are installed and properly set up on
your server
25