Konica Minolta bizhub C220 User Manual page 86

2.16 SNMP Setting Function
% When a screen appears that prompts you to enter the current password, enter the MAC Address
that is set in the machine. To check the MAC Address, from [Network Settings] of step 2, select [For-
ward] → [Detail Settings] → [Device Setting].
% The entry of a wrong SNMP password (auth-password, priv-password) is counted as unauthorized
access, if the Enhanced Security Mode is set to [ON]. If a wrong SNMP password (auth-password,
priv-password) is entered a predetermined number of times (once to three times) or more set by the
Administrator of the machine, the machine is set into an access lock state, rejecting any more logon
attempts. To cancel the access lock state, perform the Release Setting by the Administrator of the
machine.
8
Enter the new 8-digit-or-more auth-password from the keyboard or keypad.
% Press the [C] key to clear all characters.
% Touch [Delete] to delete the last character entered.
% Touch [Shift] to show the upper case/symbol screen.
% Touch [Cancel] to go back to the previous screen.
9
Touch [OK].
% If the auth-password entered does not meet the requirements of the Password Rules, a message
appears that tells that the auth-password entered cannot be used. Enter the correct auth-password.
For details of the Password Rules, see page 1-8.
10
To prevent entry of a wrong password, enter the auth-password again.
% Press the [C] key to clear all characters.
% Touch [Delete] to delete the last character entered.
% Touch [Shift] to show the upper case/symbol screen.
% Touch [Cancel] to go back to the previous screen.
11
Touch [OK].
% Go to step 12 if [auth-password/priv-password] is selected in step 6.
% If there is a mismatch in the auth-passwords, a message appears that tells that there is a mismatch
in the auth-passwords. Enter the correct auth-password.
bizhub C360/C280/C220
2
2-71