Changing The Administrator Password - Konica Minolta bizhub C220 User Manual

Bizhub c220/c280/c360 security operations user guide
Hide thumbs Also See for bizhub C220:
Table of Contents

Advertisement

2.11

Changing the Administrator Password

2.11
Changing the Administrator Password
When access to the machine by the Administrator of the machine through the Administrator Settings from
the control panel is authenticated, the machine enables the operation of changing the Administrator Pass-
word required for accessing the Administrator Settings.
The Administrator Password entered for the authentication purpose appears as "*" on the display.
Changing the Administrator Password
0
For the procedure to call the Security Settings screen on the display, see steps 1 and 2 of page 2-10.
0
Do not leave the machine with the setting screen of Administrator Settings left shown on the display. If
it is absolutely necessary to leave the machine, be sure first to log off from the Administrator Settings.
1
Call the Security Settings screen on the display from the control panel.
2
Touch [Administrator Password].
3
Enter the currently set 8-digit Administrator Password from the keyboard or keypad.
% Press the [C] key to clear all characters.
% Touch [Delete] to delete the last character entered.
% Touch [Shift] to show the upper case/symbol screen.
% Touch [Cancel] to go back to the Security Settings screen.
4
Touch [OK].
% If there is a mismatch between the currently registered Administrator Password and the Administra-
tor Password entered, a message appears that tells that there is a mismatch in the Administrator
Passwords. Enter the correct Administrator Password.
% If the Enhanced Security Mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) or more set by the Administrator of the machine, the Utility screen appears and the ma-
chine is set into an access lock state. To cancel the access lock state, settings must be made by
the Service Engineer; or, turn off, and then turn on, the main power switch of the machine. If the
main power switch is turned off and on, the access lock state is canceled after the lapse of time set
for [Release Time Settings]. When the main power switch is turned off, then on again, wait at least
bizhub C360/C280/C220
2
2-48

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bizhub c280Bizhub c360

Table of Contents