bezel and slide the drive forward slightly to provide more room for you to work.
See the sections in Chapter 10 titled "Removing and Replacing the Front Bezel"
and "Installing a Drive in a 5.25-Inch Drive Bay" for instructions.
The battery is mounted in a socket labeled "BATTERY" at the upper front-right
corner of the system board (as you face the side of the system) (see Figure 9-1).
Pry the battery out of its socket with your fingers or with a blunt, nonconductive
object, such as a plastic screwdriver (see Figure 9-9).
battery
BATTERY socket
)LJXUH 6\VWHP %DWWHU\ DQG %DWWHU\ 6RFNHW
Orient the battery with the side labeled "+" facing up. Then insert the battery
into the socket, and snap it into place.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
Installing System Board Options
9-15