Dell Precision 410 User Manual page 136

Dell Precision 410 Mini Tower Systems User's Guide
10-6
I
The 5.25-inch drive bays can accommodate any of the following types of half-height
drives:
A CD-ROM or tape drive that uses the secondary EIDE interface or the second-
ary SCSI interface on the system board
Any 5.25-inch device that uses its own controller card
NOTE: For information on configuring, connecting, and installing SCSI drives, see
"Installing SCSI Devices" found later in this chapter.
To install a drive in a 5.25-inch drive bay, follow these steps:
Check the documentation that accompanied the drive to verify that the drive is
configured for your computer system. Change any settings necessary for your
configuration.
If you are installing an EIDE CD-ROM or EIDE tape drive, configure the drive for
the cable select setting.
If you are installing a SCSI device, make sure the device has termination disabled.
See "Installing SCSI Devices" found later in this chapter.