Dell Precision 410 User Manual page 186

Found Plug and Play
ISA card: Plug and Play
ISA Card Name .
NOTICE: Boot Device
Not Active! CSN= Card
Select Number .
One or more active
devices have been
reconfigured -- sys-
tem requires reboot.
Press any key to
reboot system.
The Plug and Play
ISA card has been
successfully
configured.
Card Count Plug and
Play ISA cards have
been successfully
configured.
ERROR: Insufficient
CM Memory
ERROR: Fatal BIOS
error Internal Error
Code.
ERROR: Could not
read NVS,
Error=Internal Error
Code.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
Dell Precision 410 Mini Tower Systems User's Guide
C-8
This message appears at
system start-up for each
Plug and Play ISA expan-
sion card recognized by
the Configuration
Manager.
A boot device was found
to be inactive.
You modified the
resource values of one or
more PCI or Plug and Play
ISA expansion cards.
The Configuration Man-
ager has successfully
configured the given
number of cards.
There is not enough
memory available to the
Configuration Manager
for it to run.
A BIOS call failed with an
internal error. The most
likely cause is an incom-
patibility between the
BIOS and the Configura-
tion Manager.
An attempt to read the
NVRAM failed.
Status message; no action is required.
Status message; no action is required. The
Configuration Manager automatically config-
ures and activates the device.
Reboot the system to reconfigure the card(s).
If this message does not match the number
of Plug and Play ISA expansion cards installed
in your computer, reinstall any Plug and Play
expansion cards not listed and reboot the
system.
Disable any TSR programs or any unneeded
device drivers.
See the chapter titled "Getting Help" in your
Diagnostics and Troubleshooting Guide for
instructions on obtaining technical assistance.
See the chapter titled "Getting Help" in your
Diagnostics and Troubleshooting Guide for
instructions on obtaining technical assistance.