Dell Precision 410 User Manual page 38

Dell Precision 410 Mini Tower Systems User's Guide
2-4
Double-click the Services icon in the Control Panel. AutoShutdown and
ThermalShutdown should be listed with the status of Started.
The Asset Tag utility and Auto Power On utility (if installed) are located in the
c:\dellutil directory on the drive containing the Windows NT 4.0 system files.
To remove a service, perform the following steps:
UHPRYHH[H
The Asset Tag utility allows you to enter an asset tag number for the computer. The
default System Setup screens (see Figure 3-1) do not show the asset tag number
unless you enter one using this utility.
NOTE: The Asset Tag utility does not function correctly under Windows NT or Win-
dows 95. However, you may be able to run the utility in Windows NT by booting from
a DOS diskette or diagnostics diskette, exiting to the DOS prompt, and then entering
the asset command on the DOS command line.
You can use the Asset Tag utility to enter an asset tag number that you or your com-
pany assign to the computer; you can also use it to reenter the computer's service tag
number if that becomes necessary.
Use the asset command from an MS-DOS prompt. To view existing asset tag and ser-
vice tag numbers, type asset and press <Enter>. (You can also view the asset tag
number using the System Setup program described in Chapter 3.)
An asset tag number can have up to ten characters; any combination of characters
excluding spaces is valid. To assign or change an asset tag number, type asset and a
space followed by the new number; then press <Enter>. For example, type the fol-
lowing command line and press <Enter>:
asset 1234$ABCD&
When prompted to verify the asset tag number, type y and press <Enter>. The system
then displays the new or modified asset tag number and the service tag number.
To delete the asset tag number without assigning a new one, type asset /d and
press <Enter>.