Dell Precision 410 User Manual page 189

WARNING: Could not
configure Plug and
Play Card Name.
WARNING: Could not
configure PCI
device,
ID=DeviceID.
Failed to configure
Number of Total
Count Plug and Play
ISA devices. Use
your system's con-
figuration utility
to resolve con-
flicts. Press any
key to continue.
WARNING: Boot Device
conflict detected!
CSN=Card Select Num-
ber Error=Error.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
FRQWLQXHG
The card(s) mentioned are
not fully configured due
to resource conflicts.
One of the devices is
attempting to use one or
more resources assigned
to the system's boot
device.
If you do not know the allowable resource
values for your Plug and Play or PCI expansion
card, use the following procedure to locate
and resolve the resource conflict:
See "Removing a Card" in Chapter 4 for
instructions.
The ICU should automatically configure
your Plug and Play or PCI expansion card.
See "Adding a Listed Card" in Chapter 4
for instructions.
If your Plug and Play or PCI expansion card is
not automatically configured when you reboot
the system with all other cards removed, you
should contact the manufacturer of the card
or see the chapter titled "Getting Help" in
your Diagnostics and Troubleshooting Guide .
Perform the following procedure:
err
This card is attempting to use one or
more resources required by the system's
boot device.
ISA Configuration Utility Messages C-11
config