Dell Precision 410 User Manual page 82

NOTE: When you modify an unlisted card, the ICU cannot show you the valid
resources for the card. Therefore, you must have documentation from the card
manufacturer that describes the resources and resource settings that the card
can use.
You have completed this procedure; do not proceed to step 5.
For example, if you click the box beneath IRQ, the Add, Modify, and Remove but-
tons change to Add Interrupt, Modify Interrupt, and Remove Interrupt. When you
click one of these buttons, a smaller Specify list box (in this case, Specify Inter-
rupt) appears.
If you are providing a value for the IRQ or DMA resource, click the down arrow
beneath Available Resources. Click the value you want to assign to the resource.
If the resource can be shared with another card or device, click Sharable. Then
click OK.
If none of the values for the DMA or IRQ resource match the allowable values for
your unlisted card (as indicated in the card's documentation), select one of the
available values offered by the utility and click OK.
If you are providing values for the I/O port or memory resource, you must enter
the starting and ending addresses in hexadecimal format using the two fields
provided by the Specify Memory or Specify I/O Port dialog box.
A message box appears, notifying you either that the card is using its default set-
tings or that it cannot use its default settings and must be reconfigured.
Dell Precision 410 Mini Tower Systems User's Guide
4-12