Easycoder Pf2/4I Printers - Intermec EasyCoder PM4i Installation Instructions Manual

Serial/industrial interface kit

Hide thumbs Also See for EasyCoder PM4i:

Table of Contents

Chapter 2 — Physical Installation

EasyCoder PF2/4i Printers

• Switch oﬀ the printer and disconnect the power cord.

• Disconnect all communication cables.

• Remove the front/left-hand cover as follows.

Th e electronic compartment contains wires and compo-

nents with dangerous voltage (up to 380V). Make sure that

the printer is switched oﬀ and the power cord is discon-

nected before the left-hand cover is removed.

• Open the right-hand door.

• Using a #T20 Torx screwdriver, remove the three screws and lift the

cover up so it disengages the bottom plate.

• Swing out the rear part of the cover so you can disconnect the console

cable from the CPU board.

• Put the cover aside on a soft cloth or similar to avoid scratches.

Serial/Industrial Interface Kit Installation Instructions

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the EasyCoder PM4i and is the answer not in the manual?