Connecting Your Phone To The Network; Connecting The Phone To The Wireless Network - Cisco Small Business SPA502G User Manual

Installing Your Phone

Connecting Your Phone to the Network

Connecting Your Phone to the Network

STEP 1
STEP 2
NOTE
STEP 1
STEP 2
STEP 3
Cisco Small Business IP Phone SPA 50X User Guide (SPCP)
If you are using an Ethernet connection:
Insert one end of the Ethernet cable into the network port on the phone body
marked "SW."
Insert the other end of the Ethernet cable into the appropriate device, such as a
network switch, on your network.

Connecting the Phone to the Wireless Network

You can use the Cisco WBP54G Wireless-G Bridge for Phone Adapters to connect
the IP phone to a Wireless-G network instead of the wired local network.
• This procedure requires the optional Cisco IP Phone PA100 power adapter
to provide power to the WBP54G.
• Cisco does not recommend connecting a PC to the phone when it is
operating wirelessly.
To connect your phone to the Cisco WBP54G:
Configure the Cisco WBP54G using the Setup Wizard. See the instructions in the
Wireless-G Bridge for Phone Adapters Quick Installation Guide
cisco.com. See Appendix A, "Where to Go From Here,"
and locations.
During the Setup Wizard process, connect the Ethernet network cable of the
WBP54G to the back of the IP phone base station into the slot marked "SW." See
the "Phone Connections"
Connect the power cable of the WBP54G to the power port on the IP phone base.
graphic.
2
, available on
for a list of documents
24