Connecting Your Phone To The Network; Connecting Your Phone To The Wired Network; Connecting The Phone To The Wireless Network - Cisco SPA50 Series User Manual

Hide thumbs Also See for SPA50 Series:

Table of Contents

Installing Your Phone

Connecting Your Phone to the Network

STEP 1

STEP 2

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

Cisco Small Business SPA50X and SPA51X Series SIP IP Phone User Guide

The phone can be connected to the network by using a Cat5e or higher Ethernet

cable or through a wireless network connection.

To connect the phone by using an Ethernet cable:

Insert one end of the Ethernet cable into the network port on the RJ-45 phone port

marked "SW."

Insert the other end of the Ethernet cable into the device, such as a switch.

You can use a wireless device, such as a Cisco Wireless-N Bridge for Phone

Adapters (WNBP), to connect the IP phone to a wireless network. This example

procedure requires the Cisco PA100 power adapter to provide power to the

Cisco WNBP. Cisco does not recommend connecting a PC to the network by using

the phone when it is operating wirelessly.

To connect your phone to the Cisco WNBP:

Configure the Cisco WNBP by using the Setup Wizard.

When instructed to do so by the Setup Wizard, insert the Ethernet cable of the

wireless bridge into the RJ-45 phone port marked SW, located on the back of the

IP phone base station.

Connect the power cable of the Cisco WNBP to the power port on the phone

base.

Connect one end of the IP phone power adapter into the power port of the

wireless bridge.

Connect the other end of the IP phone power adapter into an electrical outlet.

Table of Contents