Chapter 2 Connecting To The 10Gbe Ptm Cli - Dell PowerEdge M420 User Manual

Rev 1.00
2 Connecting to the 10GbE PTM CLI
If you are connecting to the system over a network, you will need an SSH client that supports
ZModem file transfer. The examples in this document use Secure CommNet v2.35 (download
from www.radient.com). After you download the software, some initial configuration is necessary.
Please follow the next configuration steps; when using a different client software, similar settings
should be available.
If you are connecting directly to the serial port of the Chassis Management Console (CMC), skip
to step (9).
1. Go to Setup => SSH2 settings, and set the compression to
2. Go to Setup => Terminal Settings
8
Figure 4: Setup > SSH2 Settings
Figure 5: Set Compression to "none"
none
.
Software User's Manual