Chapter 3 Command Line Interface (Cli) Reference; Cli Privilege Levels; Quick Reference - Dell PowerEdge M420 User Manual

Rev 1.00
3 Command Line Interface (CLI) Reference
10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described
in this section after successfully connecting to the 10GbE PTM CLI according to the procedure
described in Section 2, "Connecting to the 10GbE PTM CLI," on page
3.1

CLI Privilege Levels

The 10GbE PTM supports the following user privilege levels:
• USER - Common user level, indicated by the # prompt
• ADMIN - Administrator level, indicated by the & prompt
Different commands are available in different privilege levels. The command reference indicates
the required privilege level for each command that requires a privilege level higher than USER.
3.2

Quick Reference

Table 5 provides a quick reference to the CLI commands:
Command name
General Commands
help
exit
login
Software Image Commands
show image ver
copy image from-file
Device Commands
show device temp
Port Commands
show port link
12
Table 5 - List of Commands
Short Description
Shows the list of available commands
Exit from the 10GbE PTM CLI
Change privilege level
Shows the software image version
Upload new software image to the 10GbE PTM
Shows the temperature of a specified device
Shows port link state
8.
Reference
Section 3.4.1, "help," on page 13
Section 3.4.2, "exit," on page 14
Section 3.4.3, "login (ADMIN)," on
page 14
Section 3.5.1, "show image ver," on
page 14
Section 3.5.2, "copy image from-file,"
on page 15
Section 3.6.1, "show device temp
(ADMIN)," on page 15
Section 3.7.1, "show port link," on
page 16
Software User's Manual