Dell PowerEdge M420 User Manual page 22

Rev 1.00
The system is now waiting for the file to be transferred from the SSH client.
Step 5. In your SSH client, initiate file transfer by clicking Transfers and then providing the path
to the SW binary file.
Step 6. Exit the bootload. Run: "exit"
Step 7. Power cycle to allow for the SW to take effect. From the CMC CLI, type the following
command:
$ racadm chassisaction -m switch-<n> powercycle
Where n is the number of the switch, 2 in our example.
Step 8. Wait at least 20 seconds to allow for the boot loader to load.
22
Figure 14: Bootloader
Figure 15: Transfer File
Software User's Manual