Dell PowerEdge M420 User Manual page 20

Rev 1.00
After loading the .pfw file, both the software and firmware will be programmed onto the
10GbE PTM.
Note The update process takes a few minutes.
At the end of this process, the following message will be displayed at the prompt:
# Received update image successfully. Changes will take effect after
next reboot.
#
Step 6. Exit the 10GbE PTM CLI to the CMC command line. Run:
# exit
Step 7. Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command
line type the following command:
$ racadm chassisaction -m switch-<n> powercycle
Step 8. Wait for 20 seconds, and then connect to the 10GbE PTM. Run:
$ connect switch-<n>
You will be able to view the progress of the SW update.
Step 9. At the end of a successful SW update process, the following message will be displayed:
FW updated successfully!
Welcome to the Dell 10GbE PTM Management Console firmware X.X.XXX-<date stamp>
#
20
Figure 13: Transferring the .pfw File
Software User's Manual