Cli Command Reference Conventions; General Commands - Dell PowerEdge M420 User Manual

Dell 10Gb Ethernet Pass Through II
Command name
show port module
Debug Commands
cr_read
cr_write
3.3

CLI Command Reference Conventions

This section describes the 10GbE PTM CLI commands.
For each command, the following information is provided:
• Synopsis:
Lists the command name and any required or optional parameters. Variable parameters (like port
numbers) are shown in italics. Optional parameters are shown in square brackets, e.g.
[optional_parameter]. Required parameters are shown with no brackets.
• Description:
Provides a detailed description of the command and of all its parameters
• Example:
Usage example and command output.
For purpose of automation, the symbol '#' is used to indicate a comment that extends until the
next new-line character.
3.4

General Commands

3.4.1
help
Synopsis:
help
Description:
Show the list of all available commands.
ADMIN: when in ADMIN mode, this command will also show commands that require
ADMIN privilege level.
Example:
# help
Table 5 - List of Commands
Short Description
Shows uplink module parameters
To read a 32 bit register from device number
device_num.
To write a data DWORD to address
0xHex_address to device number
device_num.
Reference
Section 3.7.2, "show port module," on
page 17
Section 3.8.1, "cr_read (ADMIN)," on
page 17
Section 3.8.2, "cr_write (ADMIN)," on
page 18
Rev 1.00
13