10Gbe Ptm Status Lights - Dell PowerEdge M420 User Manual

Dell 10Gb Ethernet Pass Through II
Condition
Link up
Data activity
Link protocol mismatch
1.5

10GbE PTM Status Lights

The 10GbE PTM Status lights indicate whether the switch is receiving power from the chassis, and the state
of the 10GbE PTM.
The I/O Module is on and
ready when both the blue
and green LEDs are lit.
Indication
Blinking Blue
Table 3 - LED Behavior
Green LED Amber LED
on off
on blink
off on
Figure 3: Indicator LEDs
Table 4 - 10GbE PTM states and LED configurations:
LED
Green
OFF
ON
ON BLINKING BLUE
ON ON BLUE
ON ON or BLINKING
OFF ON or BLINKING
Both the internal and external links are up
Link is up and data packets are sent or received
Section 1.3, "Link Protocol Mismatch
Refer to
Condition," on page 5
This LED can be blue or
amber. A fault is indicated
when the amber LED is
blinking. See Table 4.
10GbE PTM Status
Status
OFF
OFF Boot in Progress
10GbE PTM not ready
The CMC is identifying
the newly installed 10GbE PTM
10GbE PTM is on and operating Nor-
Fault in System
AMBER Self-diagnosed
Fault in System
AMBER CMC-detected
Description
for details.
OFF
mally
Rev 1.00
7