4.3.2 Updating Firmware For A Single Phyx Device - Dell PowerEdge M420 User Manual

Rev 1.00
# exit
Step 5. Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command
line type the following command:
$ racadm chassisaction -m switch-<n> powercycle
Step 6. Wait for 20 seconds, and then connect to the 10GbE PTM. Run:
$ connect switch-<n>
Step 7. Login to the 10GbE PTM command line interface as admin. Run:
# login admin
Step 8. To confirm that all three PhyX chips have the same firmware version, run the command:
& show image ver
Software image version: 1.0.28-201005131448-62
Component #1 FW version: 8.2.958
Component #2 FW version: 8.2.958
Component #3 FW version: 8.2.958
&

4.3.2 Updating Firmware for a Single PhyX Device

Step 1. Connect to the 10GbE PTM. Run:
$ Connect switch-<n>
Where n is the number of the switch, 2 in our example.
Step 2. To start the upgrade process for a single PhyX device (1,2, or 3), run the command:
# copy image from-file [device number]
The system is now waiting for the file to be transferred from the SSH client.
To complete the procedure, please follow Step 3 through Step 8 as described in
24
Software User's Manual
Section 4.3.1
above.