In This Chapter; Port State Description; Table 1 Port State Description - Dell PowerEdge M420 Administrator's Manual

Configuring Ports on the FC SAN Module

In this chapter

Port state description

The following table describes the possible port states.
TABLE 1
State
No _Card
No _Module
Mod_Val
Mod_Inv
No_Light
No_Sync
In_Sync
Laser_Flt
Port_Flt
Diag_Flt
Lock_Ref
Testing
Offline
Online
Dell 8/4Gbps FC SAN Module Administrator's Guide
53-1001345-01
•
Port state description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
•
Port mapping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Port state description
Description
No interface card present
No module (GBIC or other) present
Module validation in process
Invalid module
The module is not receiving light
Receiving light but out of sync
Receiving light and in sync
Module is signaling a laser fault
Port marked faulty
Port failed diagnostics
Locking to the reference signal
Running diagnostics
Connection not established (only for virtual ports)
The port is up and running
Chapter
2
3