Dell PowerEdge M420 Administrator's Manual page 72

B
portShow
portDisableReason
portCFlags
portFlags
portType
portState
Protocol
portPhys
portScn
port generation number
portId
portIfId
portWwn
portWwn of devices(s) connected
Distance
58
Provides an explanation for the port's disabled status, if it has not been
disabled by portDisable or portCfgPersistentDisable.
Port control flags.
A bit map of port status flags, including information on the type of port,
whether it is fully online, and whether logins have been accepted.
The port's type and revision numbers.
The port's SNMP state:
Online Up and running.
Offline Not online, see portPhys for more detail.
Testing Running diagnostics.
Faulty Failed diagnostics.
Persistently Disabled
Persistently disabled.
Protocol used by the port: FC or FCoE.
The port's physical state:
No_Card No interface card present.
No_Module No module (GBIC or other) present.
No_Light Module is not receiving light.
Mod_Inv Incompatible vendor or module speed mismatch.
No_Sync Receiving light but out of sync.
In_Sync Receiving light and in sync.
Laser_Flt Module is signaling a laser fault.
Port_Flt Port marked faulty.
Diag_Flt Port failed diagnostics.
Lock_Ref Locking to the reference signal.
The port's last State Change Notification.
The port's generation number for the last offline state change.
The port's 24-bit port ID.
The user port's interface ID.
The port's world wide name.
The World Wide Port Names of connected devices.
The port's long-distance level. In the case of LD mode, the user configured
distance and actual distance also are displayed. See portCfgLongDistance for
information on long distance levels.
Dell 8/4Gbps FC SAN Module Administrator's Guide
53-1001345-01