Ivr Options - Linksys SPA1001 Administrator User Manual

Chapter 2 Getting Started
To enter a period, use the star key (*).
When entering a value, such as an IP address, to exit without entering any changes, press the * (star) key
twice within half a second. Otherwise, the * is treated as a decimal point.
After entering a value, such as an IP address, press the # (pound) key to indicate you have finished your
selection. To save the new setting, press 1. To review the new setting, press 2. To re-enter the new
setting, press 3. To cancel your entry and return to the main menu, press * (star).
For example, to enter the IP address 191.168.1.105 by keypad, press these keys: 191*168*1*105. Press
the # (pound) key to indicate that you have finished entering the IP address. Then press 1 to save the IP
address or press the * (star) key to cancel your entry and return to the main menu.
If the menu is inactive for more than one minute, the Linksys ATA times out. You need to re-enter the
menu by pressing ****.
Step 5 To exit the menu, hang up the telephone.
The settings you have saved take effect after you hang up the telephone. The Linksys ATA may reboot at this
time.

IVR Options

Table 1-25
Table 1-25 IVR Options
IVR Action
Enter IVR Menu
Exit IVR Menu
Check DHCP
Enable/Disable DHCP
Check WAN IP Address
Set Static IP Address
Check Network Mask
Document Version 3.1
summarizes the options provided by the IVR.
IVR Menu Choice Parameter(s)
* * * * None
3948 None
100 None
101 Enter 1 to enable
Enter 0 to disable
110 None
111 Enter IP address using
numbers on the telephone
key pad. Use the * (star) key
when entering a decimal
point.
120 None
Using the Interactive Voice Response Interface
Notes
Ignore SIT or other tones until you hear,
"Linksys configuration menu. Please
enter option followed by the pound key
or hang-up to exit."
IVR announces if DHCP in enabled or
disabled.
Requires password
IVR announces the current IP address of
the WAN port.
DHCP must be "Disabled," otherwise
you hear, "Invalid Option," if you try to
set this value.
Requires password
IVR announces the current network
mask of Linksys ATA.
Linksys ATA Administrator Guide
2-19