Serial Configuration Settings - Avaya AP-3 User Manual

Access point

Hide thumbs Also See for AP-3:

Table of Contents

Serial Configuration Settings

The serial port interface on the AP is enabled at all times. See

Address using Serial Port

interface via the serial port. You can configure and view following

Flow Control

Serial Data Bits

for information on how to access the CLI

Select the serial port speed (bits per

second). Choose between 2400, 4800,

9600, 19200, 38400, or 57600; the default

Baud Rate is 9600.

Select either None (default) or Xon/Xoff

(software controlled) data flow control.

To avoid potential problems when communicating

with the AP through the serial port, Avaya

recommends that you leave the Flow Control

setting at None (the default value).

This is a read-only field and displays the

number of data bits used in serial

communication (8 data bits by default).

Avaya Wireless AP-3 User's Guide