Remote Control Precautions - NEC NC800C Installation Manual

NC800C
qualified service person.
3. Do not place any liquids on top of your
projector. Refer servicing to qualified
service personnel if liquid has been
spilled.
4. Keep any items such as magnifying
glass out of the light path of the
projector. The light being projected
from the lens is extensive, therefore
any kind of abnormal objects that
can redirect light coming out of the
lens, can cause unpredictable outcome
such as fire or injury to the eyes.
5. Do not cover the lens with the supplied
lens cap or equivalent while the projector is
on. Doing so can lead to melting of the
cap and possibly burning your hands
due to the heat emitted from the
light output.
6. When using a LAN cable:
For safety, do not connect to the
connector for peripheral device wiring
that might have excessive Voltage.
CAUTION: High Pressure Lamp May
Explode if Improperly Handled.
Refer Servicing to Qualified
Service Personnel.
Lamp Caution: Please
read before operation
Due to the lamp being sealed in a
pressurized environment, there is a
small risk of explosion, if not operated
correctly.There is minimal risk involved, if
the unit is in proper working order, but if
damaged or operated beyond the
recommended hours, the risk of explosion
increases. Please note that there is a
warning system built in, that displays
following message when you reach a
preset operating time "Over Time Bulb".
When you see this message please contact
your dealer for a replacement. If the
lamp does explode, smoke will be discharged
from the vents located on the back of
the unit. Do not stand in front of the
vents during the operation. This smoke is
comprised of glass in particulate form
and Xenon gas, and will not cause harm if
E-4
kept out of your eyes. If your eyes have
been exposed to this gas, please flush
your eyes out with water immediately and
seek immediate medical attention. Do
not rub your eyes! This could cause
serious injury.
WARNING:
Do not look into the lens while the
projector is on. Serious damage to
your eyes could result.
CAUTION
Never unplug the projection head power
plug from the outlet under the following
conditions. Doing so can cause damage to
the projector:
• While projecting image
• While cooling after the projector has
been turned off. (The POWER indicator
blinks in orange while the fan is rotating,
and the LCD screen is displaying
"cooling...". The cooling fan continues to
work for 3 minutes.)

Remote Control Precautions

• Handle the remote control carefully.
• If the remote control gets wet, wipe
it dry immediately.
• Avoid excessive heat and humidity.
• Do not heat, take apart, or throw
batteries into fire.
• If you will not be using the remote
control for a long time, remove the
batteries.
• Ensure that you have the batteries'
polarity (+/-) aligned correctly.
• Do not use new and old batteries
together, or use different types of
batteries together.
• Dispose of used batteries according
to your local regulations.
Important Information