NEC NC800C Installation Manual page 18

NC800C
Remove the rubber cap that
[5]
covers the primary lens
setscrew located on the
side panel of the projector.
Use a slotted screwdriver to
untighten the setscrew.
Loosen the screws on both
[6]
sides of the lens hood to
remove the hood pieces
sideways.
Holding the primary lens
[7]
unit with its guide notch up,
insert it into the projector
until it cannot go further.
While slightly pushing the
[8]
lens unit up, retighten the
lens setscrew previously
loosened.
Replace the setscrew
[9]
rubber cap to its place.
E-18
2. Setting Up Your Projector