NEC NC800C Installation Manual page 35

NC800C
Loosen the two pan angle
[7]
adjusting/fixing screws (hex
screws) and shift the anamorphic
lens horizontally so that the
projected image becomes as
illustrated below. Securely tighten
the screws after completing the
adjustment of pan angle.
Note: Be careful not to allow the
anamorphic lens to get into contact with
the primary lens when the former is
panned. If the two lenses eventually
meet, repeat step (2) above.
Direct the
anamorphic
lens to the
right
Adjust until horizontal distortions
are removed.
7
Direct the
anamorphic
lens to the
left
pan angle adjusting/fixing screws
4. Projector Adjustment
E-35