NC800C
2.1.1
Be sure to secure the power plug as follows:
(To prevent falling out)
Lift the wire stopper.
[1]
Plug the projector's power
[2]
cord into the wall outlet.
Bring the wire stopper
[3]
down to secure the power
plug.
Caution
2.1.2
When Using an EU Type Power Cable
Replace the attached wire stopper with the EU-spec. one supplied with the projector,
following the steps below:
Remove the attached
[1]
Japan/US-spec. wire
stopper.
Mount the EU-spec. wire
[2]
stopper.
E-14
In order to protect the projector from being damaged, DO NOT unplug the
projector's power cable from the wall outlet:
immediately after the cooling fan stops working (the fan continues working for 3
minutes after the projector is tuned off); and while a flash memory card is in use
(the memory data could be destructed).
Power plug
Japan/US-spec.
wire stopper
EU-spec. wire
stopper
2. Setting Up Your Projector
Wire stopper
1
2
Use these holes to
mount the EU type wire
stopper.
2
1