Configuration; Lamp Setup; Setup - NEC NC800C Installation Manual

NC800C
5.4

Configuration

5.4.1

Lamp Setup

Adjust
Adjusts the lamp output (brightness). Control the output at "W" increments.
• Lamp output below 70% will cause an error. Arrange the setting so that the lamp output
Note
becomes 70% at least.
Feedback
Sets the lamp brightness constant mode that uses a brightness sensor.
Disable
Enable
5.4.2

Setup

This menu is for service personnel. For the procedure to use it, refer to "5.1. When you use
the service personnel menu" (page E-36).
Douser Mode
The douser function
dealer/distributor to perform the setting.
Disable
Enable
← Displays the lamp output (%) with regard to the setting.
← Adjusts the lamp brightness.
← Displays the currently selected item with asterisk (*).
← Displays the setting.
Disables the lamp brightness constant mode.
Enables the lamp brightness constant mode.
will be activated
← Displays the currently selected item with asterisk (*).
← Displays the setting
Disables the douser mode.
Enables the douser mode.
when signals are
5. LCD Menu
switched. Request your
E-39