Cf_Ddots Command; Cf_Dline Command; Cf_Setpcadj Command - Canon LV-7565 Specification

Expand Serial Command Specification

8.5.6. CF_DDOTS Command

Command "CF_DDOTS_%1" [CR]
"0100 ~ nnnn" -------- Directly set Display Dots
%1
"UP" --------------------- Display Dots setting value +1
"DN" --------------------- Display Dots setting value -1
Set Display Dots. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable

8.5.7. CF_DLINE Command

Command "CF_DLINE_%1" [CR]
"0100 ~ nnnn" -------- Directly set Display Line
%1
"UP" --------------------- Display Line setting value +1
"DN" --------------------- Display Line setting value -1
Set Display Line. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable

8.5.8. CF_SETPCADJ Command

Command "CF_SETPCADJ" [CR]
N/A
%1
"EXT6" ~ "EXT60"
1. Execute the setting value in PC adjustment menu to show up on the screen.
When %1 is directly set by PC Control Command as below and Screen
Control Command, the Command will not be executed. This Command,
"CF_SETPCADJ" is to execute the setting value. (Only valid when it is in
the normal Power On state.)
Details
2. When %1 is "EXT6" ~ "EXT60" is set to %1, content specified %1 by EXT
No.6 (not XGA No.1) will be displayed.
Acceptable
Response
Unacceptable
"nnnn" means maximum value. This result of current
Dots – Horizontal Position
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
"nnnn" means maximum value. This result of current
Line – Vertical Position
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
*CF_FSYNC *CF_TDOTS
*CF_CLAMP *CF_H-POS
*CF_V-POS *CF_DLINE
*CF_DDOTS *CF_FLSCREN
"000" [CR]
"101" [CR] ---- When Input is Video series
Page 20 of 46
Total
Total