Screen Control Command; Cf_Screen Command; Cf_Flscren Command; Cf_True Command - Canon LV-7565 Specification

Expand Serial Command Specification

8.7. Screen Control Command

8.7.1. CF_SCREEN Command

Command "CF_SCREEN_%1" [CR]
Input is
Computer
%1
Input is
Select Screen Size. (Only valid when it is in the usual Power On state)
When Input does not meet the requirement for the specified %1, the response
Details will be "101" [CR], and the command is not executed..
Note) "WIDE" / "NORMAL" is available when Input signal is 4:3.
Acceptable
Response
Unacceptable

8.7.2. CF_FLSCREN Command

Command "CF_FLSCREN_%1" [CR]
"ON" ---------- Select Full Screen
%1
"OFF" --------- Cancel Full Screen
Input is
Computer
Details
Input is
Acceptable
Response
Unacceptable

8.7.3. CF_TRUE Command

Command "CF_TRUE_%1" [CR]
"ON" ---------- Select True mode
%1
"OFF" --------- Cancel True mode
Set / Cancel True mode.
Details
Only valid when it is in the usual Power On state and Input is Computer.
Acceptable
Response
Unacceptable

8.7.4. CF_DZCENT Command

Command "CF_DZCENT_%1" [CR]
%1 "CENT" ------- Cancel Digital Zoom (CENT: "CENTER")
Cancel Digital Zoom mode.
Details
Only valid when it is in the usual Power On state and Input is Computer.
Acceptable
Response
Unacceptable
"WIDE" --------- Select 16:9 display
"TRUE" ---------- Select True display
"DZOOM_UP"--- Zoom Out with Digital Zoom
"DZOOM_DN" -- Zoom In with Digital Zoom
"NORMAL" ------ Select 4:3 display
Video "WIDE" ---------- Select 16:9 display
(This command is not available when 16:9 wide signal)
"000" [CR]
"Error Code" [CR]
Set / Cancel Full Screen. (Only valid when it is in the usual
Power On state)
The value set by this Command will not be saved to the
Projector. Therefore, when All Off the Projector, the value will
return to the original setting. (Stay in Stand by mode)
Invalid
Video
"000" [CR]
"Error Code" [CR]
"000" [CR]
"101" [CR] ---- When Input is Video series
"000" [CR]
"101" [CR] ---- When Input is Video series
Page 24 of 46