Cf_H - Pos Command; Cf_V - Pos Command; Cf_Ddots Command - Canon LV-7392A Command List

LV-7292A/LV-7297A/LV-7392A/LV-7393A/LV-7398A/LV-8227A/LV-7292M/LV-7297M/LV-8227M
8.5.4 CF_H – POS Command
Command "CF_H-POS_%1"[CR]
"0000~nnnn" --- Directly select Horizontal Position setting value
"nnnn" shows maximum value, it is current Total Dots value - Display Dots value
%1
"UP" -------------- Current Horizontal Position setting value + 1
"DN" -------------- Current Horizontal Position setting value - 1
Set Horizontal Position value of PC signal.
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.5 CF_V – POS Command
Command "CF_V-POS_%1"[CR]
"0000~nnnn" --- Directly select Vertical Position setting value
"nnnn" shows maximum value, it is current Total Line value - Display Line value
%1
"UP" -------------- Current Vertical Position setting value + 1
"DN" -------------- Current Vertical Position setting value – 1
Set Vertical Position value of PC signal
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.6

CF_DDOTS Command

Command "CF_DDOTS_%1"[CR]
"0256"~"nnnn" --- Directly select Display Dots setting value
%1
"UP" -------------- Current Display Dots setting value + 2
"DN" -------------- Current Display Dots setting value – 2
Set Display Dots value of PC signal
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"nnnn" shows maximum value, it is current Total Dots value - Horizontal
Position value
Even number is available and when odd number is set, it is rounded out.
"000"[CR]
"Error Code"[CR]
-18-
Expand Serial Command Functional Specifications