Cf_Tint Command; Cf_Sharp Command; Cf_Gamma Command - Canon LV-7565 Specification

Expand Serial Command Specification

8.4.4. CF_TINT Command

Command "CF_TINT_%1" [CR]
"000 ~ 063" -------------- Directly select the Tint setting value
%1 "UP" ----------------------- Tint setting value +1
"DN" ------------------------ Tint setting value -1
Set the User control Tint value.
The value set by their Command will not be saved to the Projector.
Details
Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable

8.4.5. CF_SHARP Command

Command "CF_SHARP_%1" [CR]
"000 ~ 031" -------------- Directly select the Sharpness setting value
%1 "UP" ----------------------- Sharpness setting value +1
"DN" ------------------------ Sharpness setting value -1
Set the User control Sharpness value.
The value set by their Command will not be saved to the Projector.
Details Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable

8.4.6. CF_GAMMA Command

Command "CF_GAMMA_%1" [CR]
"000 ~ 015" -------------- Directly select the Gamma setting value
%1 "UP" ----------------------- Gamma setting value +1
"DN" ------------------------ Gamma setting value -1
Set the User control Gamma value.
The value set by their Command will not be saved to the Projector.
Details Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
Page 15 of 46