Cf_V-Pos Command; Cf_Ddots Command - Canon LV-7555 Specifications

8.5.5

CF_V-POS COMMAND

"CF_V-POS_%1"[CR]
COMMAND
"0000-nnnn"-- Directly set Vertical Position
%1
"UP"---------------- Vertical Position setting value +1.
"DN"---------------- Vertical Position setting value-1.
Set vertical position of PC signal. Only valid when it is in the usual Power
On state.)
projector. Therefore, when ALL OFF the projector, the value will return to
Details
the original setting. (stays in Stand By mode)
Note:When %1 is directly specified, this command is not enough to execute
for the screen. To show up on the image, issue CF_SETPCADJ COMMAND
Acceptable
Response
Unacceptable
8.5.6

CF_DDOTS COMMAND

"CF_DDOTS_%1"[CR]
COMMAND
"0100-"-- Directly set Display Dots value.
%1
"UP"---------------- Display Dots +1
"DN"---------------- Display Dots -1
Set Display Dots of PC signal
The value set by this Command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (stays in Stand By mode.)
Details (stays in Stand By mode.)
(Only valid when it is in the usual Power On state.)
Note:When %1 is directly specified, this command is not enough to execute
for the screen.
COMMAND.
Acceptable
Response
Unacceptable
"nnnn" means maximum value.
This value is from current Total Line value – display
Line value.
The value set by this Command will not be saved to the
"000"[CR]
"101"[CR] ---- When Input is Video Series
"nnnn" means maximum value.
This value is from current Total Dots value-Horizontal
position value
To show up on the image, issue CF_SETPCADJ
"000"[CR]
"101"[CR] ---- When Input is Video Series
Page 22 / 53