Cf_Orgmode Command; Cf_Pcstore Command; Input Control Command; Cf_Input Command - Canon LV-7565 Specification

Expand Serial Command Specification

8.5.9. CF_ORGMODE Command

Command "CF_ORGMODE_%1" [CR]
%1 "XGA1", "HDTV1080" ... etc.
After EXTn is set by PC Control series Command and CF_SETPCADJ
Details Command such as CF_FSYNC / CF_TDOTS, this Command select original
signal. (Only valid when it is in the usual Power On state)
Acceptable
Response
Unacceptable

8.5.10. CF_PCSTORE Command

Command "CF_PCSTORE_%1" [CR]
"MODE1" --------- Store current PC Adjust status to MODE 1
"MODE2" --------- Store current PC Adjust status to MODE 2
%1 "MODE3" --------- Store current PC Adjust status to MODE 3
"MODE4" --------- Store current PC Adjust status to MODE 4
"MODE5" --------- Store current PC Adjust status to MODE 5
Store current PC Adjust status (each parameter status such as Total dots) to
Mode1~5.
Details
This command operates the same operation as storing to Mode1~Mode5 in PC
Adjust Menu. (Only valid when it is in the usual Power On state)
Acceptable
Response
Unacceptable

8.6. Input Control Command

8.6.1. CF_INPUT Command

Command "CF_INPUT_%1" [CR]
"1" --------------- Select Input-1
"2" --------------- Select Input-2
%1
"3" --------------- Select Input-3
"4" --------------- Select Input-4 (Network Viewer)
Select Input. (Only valid when it is in the usual Power On state)
The operation is the same as the Projector button or the Remote Control
button "INPUT".
Details Note1) When Network Unit is not installed, and Input-4 is selected, the
Note2) When Input is set to Monitor Out, and Input-1 is selected, the response
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] ---- When Input is Video series
"000" [CR]
"101" [CR] ---- When Input is Video series
response will be "103".
will be "101".
"000" [CR]
"%%%" [CR]
Page 21 of 46