Name Definition - Canon LV-7565 Specification

Expand Serial Command Specification
3.5.1. The projector usuall issues a return commands in 1000 ms after receiving a return command.
It takes more than 1000ms for some functional execution commands (CF) to send a return
command as shown in the table below.
Command
CF_IMAGE
CF_INPUT
CF_SCREEN
CF_SYSTEM
CF_INPUT%1
CF_IMAGEADJ
3.5.2. It takes about 8 seconds for internal initialization after plugging in AC power. During this
time, it cannot process Command. Do not issue any commands.

4. Name Definition

4.1. Data from a controller to a projector is represented as Command, and data from a projector to a
controller for the incoming command is represented as Responce.
4.2. [CR]: Carriage Return Code
The Command ends carriage return code.
Also Response command ends carriage return, too.
4.3. _: Space Code
All space code is indicated by (_).
4.4. %1: Parameter in Command
When there are some parameters, the parameters are defined as %2, %3, ...
4.5. %%%: Error Code from a projector
"000": Normal Reception
See 7. Error Code Table for error number
Contents
Select Image mode
Select Input
Slect Screen size
Select System
Select Input %1 and signal at the same time
Reset Image adjustment / Store Image adjustment
Page 8 of 46